VideoRay’s Position Statement regarding Microsoft Windows Versions and upgrades
Microsoft Windows 8 and 10 require additional steps to install drivers. Windows 7 does not require these steps.
If you are unsure what downloads you require, please contact
VideoRay Hardware Drivers
Serial to USB Converter (Required for the computer to connect to the ROV.)
The Pro 4 Ultra uses a different Serial to USB Converter driver than the Pro 4. Make sure you use the correct Driver.
You must install only the correct driver. Installing the wrong driver or more than one driver may cause your system to fail.
- Pro 4 Driver
- Pro 4 Driver: Serial to USB Converter (Vendor Link, preferred)
- Pro 4 Driver: Serial to USB Converter (, in event the vendor link is unavailable)
- Pro 4 Ultra Driver
- Pro 4 Ultra Driver: Serial to USB Converter
Video Capture Device (Required for computer to capture video from the ROV. Only one of the drivers below is needed. See: Driver Installation Notes, or Contact VideoRay Support for information about which driver to install.)
You must install only the correct driver. Installing the wrong driver or more than one driver may cause your system to fail.
For more information about Video Capture Device Selection and Installation, see these Technical Notes.
- Revision D Driver: Video Capture Device
- Revsions D Firmware: Video Capture Device
- Revision A : Video Capture Device
- Startech Capture Device: Startech Capture Device
- Startech Capture Device for Windows 10 Version 2004:Startech Capture Device
GPS Antenna Driver (required if using a topside GPS antenna with your Pro 4.)
- Driver: Prolific GPS Driver
VideoRay Cockpit Software
Most Recent Update
- VideoRay Cockpit 2018 (Windows 10 and Windows 7 support)
- Released December 18, 2017 – Build 20180701
- Release Specific Installation Instructions IMPORTANT, PLEASE READ BEFORE INSTALLING
Prior Releases
- VideoRay Cockpit 2015 (Windows 7 support, not suitable for Windows 10)
- Released May 26th, 2015 – Build 20150501
- Release Specific Installation Instructions IMPORTANT, PLEASE READ BEFORE INSTALLING
Optional Configuration Files and Drivers
Required only for specific options or accessories as listed.
These versions are only required for PAM enabled versions of these options or accessories.
Rotating Manipulator Driver / Setup
Lyyn Visibility Enhancement Serial Driver (requires serial interface inside control panel) Driver / Setup
Tritech Micron Echosounder Altimeter Driver / Setup
Cygnus Ultrasonic Thickness Gauge Driver / Setup
Teledyne RDI DVL (Doppler Velocity Log) Driver / Setup
ROV GPS Antenna Driver / Setup
Laser Scaling Device Driver / Setup
Radiation Sensor Setup
YSI Sonde Driver / Setup
Lateral Thruster Configuration Set (includes hand controller configuration file) Driver / Setup
Contact Support